Loading ...
Loading ...
Loading ...
13-32 SUSPENSION
Tie-Rod, Rocker Arm
•
Raise the rear wheel off the ground with the jack (see
Rear Shock Absorber Removal).
Special Tools - Jack: 57001-1238
Jack Attachment: 57001-1608
WARNING
When raising the rear wheel off the ground with the
jack and removing part(s) from the motorcycle, be
sure to hold the front brake, or the motorcycle may
fall over. It could cause an accident and injury.
•
Remove:
Lower Rear Shock Absorber Bolt and Nut [A]
Upper Tie-Rod Bolt and Nut [B]
Rocker Arm Bolt and Nut [C]
Rocker Arms [D]
Rocker Arm Installation
•
Apply grease to the inside of the oil seals.
•
Replace the following nuts with new ones.
Rocker Arm Nut
Upper Tie-Rod Nut
Lower Rear Shock Absorber Nut
•
Install the rocker arms so that the marked side faces left
side.
•
Tighten:
Torque - Rocker Arm Nut: 34 N·m (3.5 kgf·m, 25 ft·lb)
Tie-Rod Nut: 34 N·m (3.5 kgf·m, 25 ft·lb)
Lower Rear Shock Absorber Nut: 34 N·m (3.5
kgf·m, 25 ft·lb)
•
Install the removed parts (see appropriate chapters).
Loading ...
Loading ...
Loading ...