Loading ...
Loading ...
Loading ...
13-28 SUSPENSION
Swingarm
•
Turn the swingarm pivot shaft [A] counterclockwise to free
the adjusting collar from the swingarm.
Make the gap between the adjusting collar and swingarm.
•
Pull out the pivot shaft to the right side and remove the
swingarm.
Swingarm Installation
•
Visually inspect the chain guide [A].
Replace the chain guide if it shows any signs of abnormal
wear or damage.
•
Apply grease to the lips of the grease seals [A].
•
Be sure to install the grease seals and sleeve [B] to the
swingarm.
•
Fit the collar [C] on the grease seal of the left side.
•
Screw the adjusting collar [A] into the frame [B] so that the
collar does not project the swingarm mating surface [C].
•
Install the swingarm and insert the swingarm pivot shaft
[A] into the adjusting collar [B] from the right side, and
tighten the pivot shaft.
NOTE
○
Tighten the swingarm pivot shaft until the clearance [C]
between the ball bearing [D] and collar comes to 0 mm
(0 in.).
Torque - Swingarm Pivot Shaft: 20 N·m (2.0 kgf·m, 15 ft·lb)
•
Using the swingarm pivot nut wrench, tighten the
swingarm pivot adjusting collar locknut [E].
Special Tool - Swingarm Pivot Nut Wrench: 57001-1597
Torque - Swingarm Pivot Adjusting Collar Locknut: 98 N·m
(10.0 kgf·m, 72 ft·lb)
Loading ...
Loading ...
Loading ...