Loading ...
Loading ...
Loading ...
APPENDIX 17-13
Cable, Wire, and Hose Routing
1. Frame Ground Terminal (The angle of ground lead is as shown.)
2. Alternator Lead
3. Rear Wheel Rotation Sensor Lead
4. Crankshaft Sensor Lead
5. Run the alternator lead under the rear wheel rotation sensor lead and crankshaft sensor lead.
6. Clamp (Hold the rubber portion of the rear wheel rotation sensor lead.)
7. Fuel Pump Lead
8. Run the fuel pump lead above the main harness.
9. Clamp (Hold the main harness. Install it to the battery case.)
10. Clamp (Hold the fuel pump lead.)
11. Exhaust Butterfly Valve Actuator Lead Connector (Place it between the fuse box and battery
case.)
12. Install the fuel pump lead connector to the bracket.
13. Install the clamp to the frame as shown.
14. Starter Motor Cable
15. Fuse Boxes
16. Run the main harness and starter motor cable between the rear frame bracket and battery case.
17. Battery Negative (–) Cable
18. Vehicle-down Sensor
19. Fuel Tank Breather Hose (Other than CAL, SEA-B1 and TH Models)
20. Main Harness
21. Run the battery negative (–) cable above the main harness and run it under the fuel tank breather
hose (other than CAL, SEA-B1 and TH models).
Loading ...
Loading ...
Loading ...