Loading ...
Loading ...
Loading ...
ELECTRICAL SYSTEM 16-53
Electric Starter System
Starter Motor Removal
•
Remove the throttle body assy (see Throttle Body Assy
Removal in the Fuel System (DFI) chapter)
•
Slide out the rubber cap [A].
•
Remove:
Starter Motor Cable Terminal Bolt [B]
Starter Motor Mounting Bolts [C]
Starter Motor [D]
Starter Motor Installation
NOTICE
Do not tap the starter motor shaft or body. Tapping
the shaft or body could damage the motor.
•
Clean the starter motor legs [A] and crankcase [B] where
the starter motor is ground.
•
Replace the O-ring [A] with a new one.
•
Apply soap and water solution to the new O-ring.
•
Tighten the starter motor mounting bolt (rear) [A] first, and
then starter motor mounting bolt (front) [B].
Torque - Starter Motor Mounting Bolts: 9.8 N·m (1.0 kgf·m,
87 in·lb)
•
Install the starter motor cable [C] as shown.
•
Tighten:
Torque - Starter Motor Cable Terminal Bolt [D]: 2.9 N·m
(0.30 kgf·m, 26 in·lb)
•
Slide back the rubber cap to the original position.
•
Install the removed parts (see appropriate chapters).
Starter Motor Disassembly
•
Remove:
Starter Motor (see Starter Motor Removal)
Starter Motor Through Bolts [A]
Loading ...
Loading ...
Loading ...