Loading ...
Loading ...
Loading ...
16-58 ELECTRICAL SYSTEM
Lighting System
This motorcycle adopt the daylight system and have a
headlight relay in the relay box. The headlight does not
go on when the ignition switch and the engine stop switch
are first turned on. The headlight comes on after the starter
button is released and stays on until the ignition switch is
turned off. The headlight will go out momentarily whenever
the starter button is pressed and come back on when the
button is released.
Headlight Beam Horizontal Adjustment
•
Refer to the Headlight Aiming Inspection in the Periodic
Maintenance chapter.
Headlight Beam Vertical Adjustment
•
Refer to the Headlight Aiming Inspection in the Periodic
Maintenance chapter.
Headlight (LED) Assembly Removal/Installation
•
Refer to the Upper Fairing Disassembly/Assembly in the
Frame chapter.
Headlight Harness Circuit Inspection
NOTE
○
Be sure the battery is fully charged.
•
Inspect the headlight fuses (see Fuse Inspection).
•
Remove the upper fairing (see Upper Fairing Removal in
the Frame chapter).
NOTICE
Do not disconnect the headlight connectors [A]. If
the headlight connectors are disconnect, the head-
light (LED) may be broken by static electricity.
•
Connect the measuring adapter [A] to the headlight con-
trol unit lead connector [B].
Special Tool - Measuring Adapter: 57001-1700
•
Inspect the ground wiring continuity as shown.
Wiring Continuity Inspection
BK/O Lead [C] ←→BK/O Lead [D]
If the wiring is not good, replace the main harness.
If the wiring is good, check the input voltage.
Loading ...
Loading ...
Loading ...