Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 83
BED RAIL TIE DOWN SYSTEM —
IF EQUIPPED
The Bed Rail Tie Down System allows you to properly
secure cargo in the truck bed.
Bed Rail Tie Down Locations
There are two adjustable utility rail cleats on each side of
the bed that can be used to assist in securing cargo.
Adjustable Cleat Assembly
Each utility rail cleat must be tightened down in one of the
detents along either utility rail in order to keep cargo
properly secured.
To move the utility rail cleat to any position on the utility
rail, turn the cleat retainer nut counterclockwise several
times. Then, pull out on the utility rail cleat and slide it to
the detent nearest the desired location. Make sure the
utility rail cleat is seated in the detent, and tighten the nut.
To remove the utility rail cleats from the side utility rails,
slide the cleat to the rectangular cutout located at the end
of the rail toward the front of the vehicle.
To remove the utility rail cleat from the front utility rail,
slide the cleat to the rectangular cutout located on the left
side of the rail.
TONNEAU COVER — IF EQUIPPED
The Tonneau Cover can be installed on the truck bed to
keep cargo out of view, and protect from inclement
weather.
The Tonneau Cover consists of the following features:
Easy roll up cover
Tonneau fore/aft locator
Crossbar inside bed locator
Rear latches
Stowage straps
NOTE:
The Tonneau Cover can be rolled up and secured at the
front of the truck bed without removing it completely.
CAUTION!
The maximum load per cleat should not exceed 250 lbs
(113 kg) and the angle of the load on each cleat should
not exceed 45 degrees above horizontal, or damage to
the cleat or cleat rail may occur.
1 — Utility Rail Detent
2 — Cleat Retainer Nut
3 — Utility Rail Cleat
2
20_JT_OM_EN_USC_t.book Page 83
Loading ...
Loading ...
Loading ...