Loading ...
Loading ...
Loading ...
66 GETTING TO KNOW YOUR VEHICLE
NOTE:
Do not force open; this will break the plastic cover.
Step Six
7. To release the wire harness, pull back on the red latch
(1), then push down on the black button (2) while
pulling the harness out.
Step Seven
8. Remove the hard top from the vehicle. Install the
provided edge protectors along the bottom edges of
the hard top, and place the hard top on a soft surface
to prevent damage.
9. Store the wire harness by removing the storage cover
on the quarter trim. Use the mechanical key blade to
pry the cover open.
Step Nine
10. Tuck the wire harness inside the storage
compartment, and replace the cover.
Step Ten
1 — Red Latch
2 — Black Button
CAUTION!
The removal of the Freedom Top requires four adults
located on each corner. Failure to follow this caution
could damage the Freedom Top.
CAUTION!
The front panel(s) must be positioned properly to
ensure sealing. Improper installation can cause
water to leak into the vehicle's interior.
The hard top assembly must be positioned properly
to ensure sealing. Improper installation can cause
water to leak into the vehicle's interior.
The hard top is not designed to carry any additional
loads, such as after-market roof racks, spare tires,
building materials, hunting or camping supplies, etc. For
optional Mopar® accessory roof racks, refer to “Roof
Luggage Rack” in “Getting To Know Your Vehicle.”
Do not move your vehicle until the top has been
either fully attached to the windshield frame and
bodyside, or fully removed.
The removal of the hard top requires four adults
located on each corner. Failure to follow this caution
could damage the hard top.
20_JT_OM_EN_USC_t.book Page 66
Loading ...
Loading ...
Loading ...