Loading ...
Loading ...
Loading ...
68 GETTING TO KNOW YOUR VEHICLE
2. Lift the frame upward, removing it from the vehicle.
Step Two
3. Store the fasteners in a secure location.
4. Repeat the procedure on the front door frame.
DOOR FRAME INSTALLATION
1. Install the front door frame first.
2. Ensure the windshield is in the “up” position.
Carefully place the front door frame in the rubber seal
at the top of the windshield, and line up the holes for
the Torx head fasteners (two for each door).
3. Swing the frame bracket around the side of the door
frame, and insert the fasteners from underneath.
Tighten with the #T40 Torx head driver until they are
snug, being careful not to cross-thread the fasteners
or overtighten. Refer to the following table for the
appropriate torque specifications for the door frame
fasteners.
Step Three
4. Set the rear door frame pin into the hole on top of the
body side, just behind the rear door opening.
5. Carefully position the top of the door frame onto the
rear belt rail and the rear of the front door frame,
making sure the rubber seals lie flat. Ensure the seals
are installed correctly to avoid water leaks.
Step Five
Step Five
WARNING!
Do not drive your vehicle on public roads with the door
and/or door frame(s) removed as you will lose the
protection that they can provide. This procedure is
furnished for use during off-road operation only.
Target Torque
Specification For
Torx Fasteners
Maximum Minimum
8.8 ft-lbs
(12 N·m)
11.0 ft-lbs
(15 N·m)
3.6 ft-lbs (5 N·m)
CAUTION!
Do not overtighten Torx fasteners. You can strip the
fasteners if they are overtightened.
20_JT_OM_EN_USC_t.book Page 68
Loading ...
Loading ...
Loading ...