Loading ...
Loading ...
Loading ...
(234,1)
北米Model "A8330BE-A" EDITED: 2022/ 7/ 26
1. Before turning the ignition switch to the
“ON” position, set the light control
switch to the “AUTO” position and push
the signal lever forward (high beam
position).
2. Turn the ignition switch to the “ON”
position and within approximately 15
seconds, press the “
/ ” (following
distance setting) switch more than 10
times consecutively.
When the sensitivity of the high beam
assist function is lowered, the high beam
assist indicator light “
” on the combina-
tion meter will flash.
NOTE
. The sensitivity of the high beam
assist function cannot be lowered
in the following conditions.
– Cruise control or Adaptive Cruise
Control indicator is illuminated.
– The EyeSight warning indicator
(yellow) is illuminated.
. The sensitivity of the high beam
assist function returns to normal
level the next time the ignition
switch is turned to the “LOCK”/
“OFF” position and the engine is
restarted.
! How to change the headlight mode
manually
S03AH0702
Change to the low beam:
When you return the turn signal lever to the
center position, the high beam assist
function will turn off and the high beam
assist indicator light will turn off.
Change to the high beam:
When you turn the light control switch to
the “
” position, the headlight mode will
be changed to the high beam.
At this time, the high beam assist function
will turn off, the high beam assist indicator
light will turn off and the high beam
indicator light will turn on.
NOTE
. After manually changing the head-
light mode to the high beam, if you
turn on the high beam assist func-
tion, return the light control switch
to the “AUTO” position.
. When manually changing the head-
light mode to the high beam, if you
turn the light control switch to the
“
” position, the instrument panel
illumination, parking lights, front
side marker lights, rear side marker
lights, tail lights and license plate
lights will be on.
! Tips for the high beam assist sys-
tem
S03AH0703
. The high beam assist function recog-
nizes the conditions surrounding the
vehicle based on the brightness of
illumination ahead of your vehicle, etc.
Therefore, the headlight mode may
switch in some situations that do not
match to the driver’s sense.
. A bicycle or cargo cycle may not be
detected.
. Under the following situations, the
brightness of ambient illumination may
not be detected correctly and the high
beam assist function may not work
properly. As a result, the glare of the
high beam may disturb the oncoming
vehicle or vehicle ahead. Also, the low
beam mode may continue although
there are no oncoming vehicles and
vehicles ahead. In the such cases,
change the headlight mode manually.
– In bad weather (fog, snow, sand
storm, heavy rain, etc.).
– When the windshield glass is dirty or
fogged.
– When the windshield is cracked or
damaged.
– When the stereo camera is de-
formed or the stereo camera lenses
are dirty.
Light control switch
232
Loading ...
Loading ...
Loading ...