Loading ...
Loading ...
Loading ...
Emergencies
bulbs, other vehicle components require re-
mo
v
al.
If you choose to change the engine compart-
ment lamps yourself, remember that it is a
dangerous area
›››
in Working in the en-
gine compar
tment on page 318
.
Always use identical bulbs with the same
designation. The name can be found on the
base of the bulb holder.
Bulbs (12 V)
Full-LED headlights are designed to last the
lifetime of the car and light bulbs cannot be
replaced. In case of headlight failure, go to an
authorised workshop to have it replaced.
Light source used for each function
Halogen headlights. Type
Dipped beam headlights H7 LL
Main beam headlights/day-
time running lights (DRL)
H15 (double element)
Side lights W5W
Turn signal PY21W NA LL
AFS bi-xenon main
headlight
Type
Daytime running lights
(DRL)
P21W SLL
Side lights W5W
AFS bi-xenon main
headlight
Type
Turn signal PY21W NA LL
Dipped beam / Main beam
Xenon bulb. Visit an
authorised workshop
for replacement.
Front fog light Type
Fog lights HB4
LED rear lights Type
Side/brake light LED
Turn signal WY21W
Reverse lights W16W
WARNING
●
Tak
e particular care when working on
components in the engine compartment if
the engine is warm. Risk of burns.
●
Bulbs are highly sensitive to pressure. The
glass can break when you touch the bulb,
causing injury.
●
When changing bulbs, please take care
not to injure yourself on sharp edges, in
particular on the headlight housing.
CAUTION
●
Remo
ve the ignition key before working
on the electric system. Otherwise, a short
circuit could occur.
●
Switch off the lights and the parking light
before changing a bulb.
●
Take good care to avoid damaging any
components.
For the sake of the environment
Please ask your specialist retailer how to
dispose of used bulbs in the proper manner
.
Note
●
Please check at r
egular intervals that all
lighting (especially the exterior lighting) on
your vehicle is functioning properly. This is
not only in the interest of your own safety,
but also that of all other road users.
●
Before changing a bulb, make sure you
have the correct new bulb.
●
Do not touch the glass part of the bulb
with your bare hands, use a cloth or paper
towel instead, since the fingerprints left on
the glass will vaporise as a result of the
heat generated by the bulb, they will be
deposited on the reflector and will impair
its surface.
●
Depending on the level of equipment fit-
ted in the vehicle, LEDs may be used for
part or all of the interior and/or exterior
lighting. LEDs have an estimated life that
60
Loading ...
Loading ...
Loading ...