Loading ...
Loading ...
Loading ...
English 59
Maintaining your appliance
Maintaining your appliance
4. Shake the graphite lubricant before
opening it. Starting with the left (front
and back) slide mechanism of the rack,
place four (4) small drops of lubricant
on the two (2) bottom tracks of the slide
close to the bearing carriers.
5. Repeat for the right (front and back)
slide mechanism of the rack.
6. Open and close the rack several times to
distribute the lubricant.
7. Replace the cap on the lubricant and
shake it again. Turn the rack over and
repeat steps 3, 4, 5 and 6.
8. Close the rack, turn rack right-side-up
and place in the oven. See installing the
gliding rack in the Using the gliding rack
section.
NOTE
Do not spray gliding rack with cooking spray or other lubricant sprays.
Oven door
WARNING
Do not allow moisture to enter the door or contact the door gasket during
cleaning. Moisture entering the door assembly and or getting on the door gasket
will damage the gasket.
Do not move or
clean gasket.
Handclean gray
areas.
The oven door has multiple surfaces that require different cleaning techniques.
The gasket on the inside surface of the oven door should never be cleaned or
moved to clean other surfaces. The gasket is made of woven material which is
essential for a good heat seal.
The inside door surface outside of the gasket should be cleaned by hand with
hot, soapy water and a soapy plastic scouring pad. Rinse and dry thoroughly with
a clean, soft cloth. Do not get the gasket wet or allow moisture to get inside the
door assembly.
The inside door surface inside of the gasket and the inside door glass are cleaned
during the oven’s self-cleaning cycle.
The outside door surface is stainless steel and should be cleaned using the
instructions on page 57.
The outside glass surface can be cleaned with glass cleaner or warm, soapy water
with a thorough rinse. Do not let moisture get inside of the door assembly.
Loading ...
Loading ...
Loading ...