Loading ...
Loading ...
Loading ...
Engine Servicing
4-11
4-11
Install the throttle body into the insulator.
Make sure of the following clearance between the throttle
body:
– Throttle body-to-bank angle sensor: more than 5 mm
– Throttle body-to-muffler: more than 5 mm
Adjust the insulator band angle and tighten the band
screw securely.
Connect the ECM 32P (Black) connector.
(1) THROTTLE BODY
(2) BAND SCREW
(3) 32P (BLACK) CONNECTOR
(1) THROTTLE DRUM COVER
(2) SCREWS
Connect the throttle cable end to the throttle drum.
Install the throttle cable to the throttle body.
Adjust the throttle grip freeplay.
Install the throttle drum cover and tighten the screws.
(1) THROTTLE CABLE END (2) THROTTLE DRUM
(3) THROTTLE CABLE (4) LOCK NUT
(1) SCREW
(2) INSULATOR
(3) ALIGN
Loosen the lock nut, then disconnect the throttle cable
from the throttle body.
Then disconnect the cable end from the throttle drum.
Loosen the insulator clamp screw, then remove the
insulator from the throttle body.
Installation
Install the insulator onto the throttle body while aligning
its slit with the lug on the throttle body as shown.
(1) LOCK NUT (2) THROTTLE CABLE
(3) THROTTLE CABLE END (4) THROTTLE DRUM
4 1
3 2
2 3
1 4
1
2
3
3
2
1
1
2 2
Loading ...
Loading ...
Loading ...