Loading ...
Loading ...
Loading ...
Service and Maintenance
3-6
3-6
(1) OIL FILTER COVER
(2) O-RINGS
(3) OIL FILTER
(4) SPRING
Oil Filter Change
Remove the left crankcase cover (page 4-46).
Remove the oil filter cover retaining plate bolt and plate.
Remove the oil filter cover and O-rings.
Remove the oil filter and spring.
(1) BOLT
(2) RETAINING PLATE
Oil Change
Change the engine oil with the engine warm.
Support the motorcycle with on its side stand.
Remove the bolts and skid plate.
1. Remove the oil filler cap/dipstick.
2. Place an oil drain pan under the engine and remove the
drain bolt on the left crankcase cover.
3. After the oil has completely drained, make sure that
the sealing washer is in good condition and reinstall
the drain bolt. Tighten the drain bolt to the specified
torque.
Torque: 22 N•m (2.2 kgf•m, 16 lbf•ft)
4. Pour recommended engine oil slowly through the oil
filler hole.
Specified engine oil:
Repsol 4-stroke motorcycle oil (SAE: 10W-30)
Capacity: 0.41 liter (0.43 US qt, 0.36 Imp qt) after draining
0.44 liter (0.46 US qt, 0.39 Imp qt) after oil filter
change
0.60 liter (0.63 US qt, 0.53 Imp qt) after
disassembly
Install the oil filler cap/dipstick.
(1) OIL FILLER CAP/DIPSTICK
(2) DRAIN BOLT/SEALING WASHER
(1) OIL FILLER CAP/DIPSTICK
(2) UPPER LEVEL LINE
(3) LOWER LEVEL LINE
Engine Oil/Oil Filter
Oil Level Inspection
Start the engine and let it idle for a 3 minutes.
Stop the engine and wait 3 minutes.
Support the motorcycle upright on a level surface.
Remove the oil filler cap/dipstick on left crankcase and
wipe the oil with a clean cloth.
Insert the dipstick without screwing it in, remove it and
check the oil level.
If the oil level is below or near the lower level line on the
dipstick, add the recommended engine oil to the upper
level line through the oil filler hole.
Specified engine oil:
Repsol 4-stroke motorcycle oil
(10W-30)
3
2
1
2
1
2
1
4
3
2
2
1
Loading ...
Loading ...
Loading ...