Loading ...
Loading ...
Loading ...
5-26
5-26
Frame Servicing
(1) OIL BOLT
(2) BRAKE HOSE
(3) BOLTS
(4) HOLDER
(5) MASTER CYLINDER
Front master cylinder
Removal/Installation
NOTICE
y Avoid spilling brake fl uid on painted, plastic or rubber
parts. Place a shop rag over these parts whenever the
system is serviced.
y When removing the brake hose bolt, cover the end of
the hoses to prevent contamination. Secure the hoses
to prevent fl uid from leaking out.
Drain the brake fluid from the hydraulic system into a
suitable container.
Remove the following:
– Brake lever
– Brake hose bolt
– Master cylinder holder bolt and holder
– Master cylinder
(1) CALIPER PISTON
Inspection
Clean the inside of the caliper.
Check for oil leakage from the caliper cylinder.
If any part of the caliper is damaged, replace the caliper
as an assembly.
Installation
Install the brake caliper onto the swingarm rail.
Connect the brake hose eyelet joint with two new sealing
washers.
Install the rear wheel (page 5-16).
Tighten the oil bolt to the specified torque.
Torque: 28 N•m (2,9 kgf•m, 21 lbf•ft)
1
(1) OIL BOLT
(2) BRAKE HOSE
(3) BRAKE CALIPER
Rear brake caliper
Removal
NOTICE
Avoid spilling brake fl uid on painted, plastic or rubber
parts.
Place a shop rag over these parts whenever the system
is serviced.
Drain the brake system.
Place a clean container under the caliper.
Remove the following:
– Brake hose oil bolt
– Sealing washers
– Brake hose eyelet
– Rear wheel (page 5-15)
– Brake caliper/bracket
– Spring pin for the pads
– Brake pads (page 5-28)
1
3
5
4
3 3
2
1
2
Loading ...
Loading ...
Loading ...