Loading ...
Loading ...
Loading ...
6-8
6-8
Electrical Servicing
Install the bank angle sensor in the reverse order of
removal.
Install the bank angle sensor with its arrow/UP mark
facing up as shown.
(1) ARROW/UP MARK
(2) BANK ANGLE SENSOR
Connect the bank angle sensor 3P (Natural) connector.
With the arrow mark on the bank angle sensor facing up,
start the engine.
Incline the bank angle sensor approximately 65 degrees
to the left or right, make sure that the engine stops after
a few seconds.
If the engine stops, the bank angle sensor is normal.
If the engine does not stop, replace the bank angle sensor.
With the arrow/UP mark on the bank angle sensor facing
up again, restart the engine.
The engine starts, the bank angle sensor is normal.
Bank angle sensor inspection
Remove the electric stay assembly from the frame (page
6-2).
Remove the screws and bank angle sensor from the
sensor bracket.
Reinstall the electric stay and removed parts in the reverse
order of removal.
(1) SCREWS
(2) BANK ANGLE SENSOR
1 1
2
2
1
Loading ...
Loading ...