Loading ...
Loading ...
Loading ...
Service and Maintenance
3-8
3-8
5. Pour in the specified transmission oil.
Specified transmission oil: ELF HTX 740
Capacity: 0.54 liter (0.57 US qt, 0.48 Imp qt) after draining
0.57 liter (0.60 US qt, 0.50 Imp qt) after
disassembly
Check that the O-ring is in good condition and install the
oil filler cap.
(1) OIL FILLER CAP
(2) O-RING
Transmission Oil
Oil Change
y Transmission oil should be changed at least every six
competitions to ensure consistent performance and
maximum service life of both transmission and clutch
components.
y Warm-up the engine before draining the oil. This will
ensure complete and rapid draining.
Remove the bolts and skid plate.
1. Support the motorcycle in an upright position on a level
surface.
2. Remove the oil filler cap from the clutch cover.
3. Place an oil drain pan under the engine to catch the oil,
then remove the drain bolt and sealing washer from the
left crankcase.
4. After the oil has drained completely, install the drain
bolt with a new sealing washer. Tighten the drain bolt
to the specified torque.
Torque: 22 N•m (2.2 kgf•m, 16 lbf•ft)
(1) DRAIN BOLT
Engine Idle Speed
Inspect and adjust the idle speed after all other engine
adjustments are within specification.
The engine must be warm for an accurate idle inspection
and adjustment.
Warm up the engine until the fan comes on, shift the
transmission into neutral, and hold the motorcycle in an
upright position.
Connect a tachometer according to its manufacturer’s
operating instruction.
Idle speed: 1,800 ± 100 min (rpm)
(1) THROTTLE STOP SCREW
2
1
1
1
Loading ...
Loading ...
Loading ...