Loading ...
Loading ...
Loading ...
Chapter 6 Operations and Measurements RIGOL
MSO7000/DS7000 User's Guide 6-37
X Cursor
X cursor is a vertical solid/dotted line that is used to make horizontal
adjustments. It can be used to measure time (s), frequency (Hz), phase (°), and
ratio (%).
Cursor A is a vertical solid line, and Cursor B is a vertical dotted line.
In the X-Y cursor mode, X cursor is used to measure the waveform
amplitude of CH1.
Y Cursor
Y cursor is a horizontal solid/dotted line that is used to make vertical adjustment.
It can be used to measure amplitude (the unit is the same as that of the source
channel amplitude) and ratio (%).
Cursor A is a horizontal solid line, and Cursor B is a horizontal dotted line.
In the X-Y cursor mode, Y cursor is used to measure the waveform
amplitude of CH2.
Press Cursor on the front panel to open the cursor measurement menu, or enable
the touch screen and then tap the function navigation icon at the lower-left
corner of the screen to open the function navigation. Then, tap the "Cursor" icon to
open the cursor measurement menu.
In the cursor measurement menu, press Mode and then rotate the multifunction
knob
to select the desired cursor mode (the default is "OFF"). Press down the
knob to select it. You can also press the Mode key continuously or enable the touch
screen to select the desired mode. The available modes are "Manual", "Track", and
"XY". When you select "OFF", the cursor measurement function is disabled.
Note: When the Time Base Mode is set to "XY", the XY cursor measurement mode is
valid.
Y Cursor (Cursor B)
Y Cursor (Cursor A)
X Cursor (Cursor A)
X Cursor (Cursor B)
Loading ...
Loading ...
Loading ...