Loading ...
Loading ...
Loading ...
RIGOL Chapter 6 Operations and Measurements
6-24 MSO7000/DS7000 User's Guide
Auto Measurement
MSO7000/DS7000 provides auto measurements for 41 waveform parameters, as
well as the statistics and analysis of the measurement results.
Quick Measurement after AUTO
When the oscilloscope is correctly connected and has detected a valid input signal,
press AUTO to enable the waveform auto setting function and open the auto setting
function menu.
: Press this key, and then the complete single period of the signal is
displayed automatically on the screen. Meanwhile, the system will make
measurements for the "frequency" of the currently displayed waveforms in a
complete single period. The measurement results are displayed at the bottom of
the screen.
: Press this key, and then multiple periods of the signal are displayed
automatically on the screen. Meanwhile, the system will make measurements
for the "frequency" of the currently displayed waveforms in a multiple periods.
The measurement results are displayed at the bottom of the screen.
: Press this key, and then one rising edge of the signal is displayed
automatically on the screen. Meanwhile, the system will make measurements
for the "rise time" of the currently displayed rising edge. The measurement
results are displayed at the bottom of the screen. By default, it is intended for
the fast edge signal.
: Press this key, and then one falling edge of the signal is displayed
automatically on the screen. Meanwhile, the system will make measurements
for the "fall time" of the currently displayed falling edge. The measurement
results are displayed at the bottom of the screen. By default, it is intended for
the fast edge signal.
: press this key, and the system returns to the last set menu.
Press Option to enter the AUTO option setting menu.
Press Lock to lock the AUTO function. If the AUTO function is unlocked,
please perform remote control over the commands.
Press Peak to Peak to enable or disable the peak-peak priority setting.
This function is intended for the shifted signal. If there is a large deviation,
you can view the signal waveform in priority when you enable the function.
Press CH to select "All" or "Open".
If you select "All", press AUTO and the system will test the 4 analog
channels (CH1-CH4) in sequence. If no signal is found on the channel, then
the channel is disabled; if a signal is found on the channel, adjust the
channel to an optimal scale to display the signal.
If you select "Open", press AUTO and the system will only test the enabled
Loading ...
Loading ...
Loading ...