Loading ...
Loading ...
Loading ...
Maintenance—Every 500 Hours
KR46761,00013D3 -19-27OCT16-1/1
Drain and Rell Engine Oil and Replace Filter
IMPORTANT: Avoid engine damage. Make sure that
area around and above engine oil ller cap (4) is
clean and clear of debris before removing cap.
1. Park machine on a level surface.
IMPORTANT: Turbocharger can be damaged
if procedure to shut down engine is
not done properly.
2. Run engine at slow idle speed without load for 5
minutes.
3. Stop engine.
4. Underneath the middle of the machine, remove cap
screws and open access cover (1).
5. Open drain valve (2) on engine oil pan. Allow oil to
drain into a container. Dispose of waste oil properly.
6. Close drain valve and access cover. Install cap screws.
7. Open right rear service door to access engine oil lter
(3).
8. Turn engine oil lter counterclockwise to remove.
Clean mounting surface on base.
9. Apply thin lm of oil to rubber gasket of new lter.
10. Install new lter. Turn lter clockwise by hand until
gasket touches mounting surface.
11. Tighten lter 1/2—3/4 turn more.
12. Open engine cover.
13. Remove ller cap (4) and ll engine with oil. See Diesel
Engine Oil—Final Tier 4 and Stage IV. (Section 3-1.)
Specication
Engine Oil With
Filter—Capacity.............................................................................. 26.0 L
6.9 gal
14. Install ller cap.
15. Start engine.
16. Stop engine, remove dipstick (5), and check oil level.
Engine is full when oil level is in the cross-hatch area.
17. Check for any leakage at lter. Tighten lter just
enough to stop leakage.
TX1225944 —UN—12OCT16
Engine Oil Drain Valve (view from under machine)
TX1225949 —UN—14OCT16
Engine Oil Filter
TX1225951 —UN—13OCT16
Engine Oil Filler Cap and Dipstick
1— Access Cover
2— Drain Valve
3— Engine Oil Filter
4— Filler Cap
5— Dipstick
18. Close service door and engine cover.
3-9-2
112321
PN=237
Loading ...
Loading ...
Loading ...