Loading ...
Loading ...
Loading ...
Troubles sometimes are caused by simple "faults" that you
can easily correct without the help of a service technician by
first checking a few basic remedies.
Before you call or take your unit to an Authorized ProScan
TV Servicenter, look below for the type of trouble you are
experiencing. Then perform the simple checks and
adjustments listed for that trouble.
TV will not turn on
• Check to make sure it is plugged in.
• Check the wall receptacle (or extension cord) to make sure
it is "live" by plugging in something else.
• Maybe batteries in remote control are "dead".
• Maybe remote control was not aimed at remote sensor.
• Make sure power cord is fully inserted into back of TV.
Controls don't work
• If using remote control, make sure remote is in '"IV Mode"
by first pressing rv button.
• Try unplugging set for two minutes and then turning it on
again.
• Make sure power cord is fully inserted into back of TV.
Intermittent or no remote
• Maybe something was between the remote and the remote
sensor.
• Maybe the remote was not aimed directly at the component
(TV or VCR) you were trying to control.
• Maybe remote is not in "TV Mode". Press the TVbutton so
remote will control TV.
• Maybe batteries in remote are weak or dead. Try replacing
batteries.
• Maybe batteries were installed incorrectly. Try replacing
batteries correctly.
Turns off while playing
• SLEEPTIMERfunction may have been activated.
• ALARMOFFfunction may have been activated.
• Electronic protection circuit may have been activated because
of a power surge. Wait 30 seconds and then turn on again. If
this happens frequently, the voltage in your house may be
abnormally high.
• Make sure power cord is fully inserted into back of TV.
Turns on unexpectedly
• ALARMONfunction may have been activated.
ALARM does not turn offTV at correct time
• Check ALARMON/OFFfunction. Must be set to ON.
• Check to make sure CLOCKfunction is set to the correct time.
Blank screen
• Maybe Channel 90, 91, or 92 is selected, but device connected
to those iNPUTjacks is not turned on.
• Try another channel.
No sound, picture okay
• Maybe sound is muted. Try pressing VOLUMEup button to
restore sound.
• Maybe TV's speakers are turned off. Check SPEAKERSON/OFF
function.
• If using channel 90 (S-VIDEO input) with an S-VHS component,
remember to also connect the component's Land a AUOIOOUT
jacks to the TV's Land n INPUT1jacks.
• Maybe SPEAKERswitch on back of TV is not in the INTERNAL
position.
Can't select certain channel
• Channel may not be in Channel Memory. Try pressing two
number buttons.
• If using a VCR, check to make sure the "I'VNCRswitch on the
VCR is in the correct position.
• To select cable channels 100 through 128, press number
button I until 1-- appears. Then press the other two number
buttons. The CABLE/AIRfunction must be in CABLEmode to
select channels higher than 69.
Loading ...
Loading ...
Loading ...