User Manual - Page 215

For ALHAMBRA 2022.

Loading ...
Loading ...
Loading ...
Operating modes
Navigation
1)
Intr
oduction
General information
A GPS (Gl
obal Positioning System) satellite
system locates the current position of the ve-
hicle. The vehicles sensors measure the dis-
tance travelled. The measurements are com-
pared with the stored detailed map resour-
ces, according to road indications stored in
them. Traffic reports, if any, will also be taken
into account in the route calculation (dynam-
ic route guidance
››
page 220). Using all the
data available, the Infotainment system cal-
culates the optimum route to the destination.
The destination is defined by entering an ad-
dress or a point of interest, e.g. a petrol sta-
tion or hotel.
Navigation announcements and graphic rep-
resentations will guide you to your destina-
tion.
Depending on the country, some functions of
the infotainment system will not be available
on the screen when travelling higher than a
certain speed. It is not a malfunction, but is
due to compliance with legislation.
CAUTION
The navigation announcements may be in-
accur
ate (e.g. due to out-of-date data).
Instructions for navigation
When the Infotainment system is unable to re-
ceiv
e any data from GPS satellites (tunnels,
garages), navigation can still continue using
the vehicle sensors.
Possible limitations in navigation
In areas that are not or are only partially digi-
tised (e.g. insufficient definition of one-way
streets and road categories), the Infotain-
ment system will still attempt to provide route
guidance.
In the case of missing or incomplete naviga-
tion data, it may not be possible to determine
the exact position of the vehicle. This may
mean that navigation is not as precise as usu-
al.
Navigation area and update of navigation
data
Road layouts change continuously. There-
fore, if the navigation data are not updated,
then errors or inaccuracies may occur.
SEAT recommends updating navigation data
on a r
egular basis.
Updating and using navigation da-
ta from an SD card
The SD card is factory fitted in slot 2 for SD
car
ds.
Navigation data that is currently valid for this
unit in order to allow all functions to be used
in full.
Updating navigation data
The current navigation data can be downloa-
ded in the internet at www.seat.com and stor-
ed in a SD card compatible with the unit.
Suitable SD Cards can be acquired at SEAT
dealerships.
The procedure is described on the internet at
www.seat.com.
Using navigation data
Insert the memory card
page 209.
Wait for the testing icon to disappear.
If the inserted memory card contains valid
navigation data, the following message ap-
pears: “The source contains the
»
1)
Only available for the model: Navi System
213
Loading ...
Loading ...
Loading ...