Loading ...
Loading ...
Loading ...
High quality digital-to-digital copying can
be accomplished if both Palmcorders
incorporate the DV Input/Output (i.LINK)
Connector (DV interface cable (i.LINK) is
not supplied).
Source (Playing)
Palmeorder
DV Input/Output
Connector
Recording
Palmcorder
DV Interface Cable (i.LINK)
(optional)
r Before you begin
• Connect both Palmcorders to their
power sources.
• Connect the two Palmcorders using the
DV interface cable (i.LINK)
(4-pm to 4-pin).
• Turn both Palmcorders ON.
1
2
3
4
5
Insert a pre-recorded tape into the
source (playing) Palmcorder, and set
POWER to VCR.
Insert a blank tape with the record
tab closed into the target (recording)
Palmcorder and set POWER to VCR.
Press PLAY on the source
Palmcorder. When the tape reaches
the point you want to start dubbing,
press PAUSE.
Hold down REC and press PLAY on
the target (recording) Palmcorder or on
the remote control (optional, page 64).
Press PAUSE to pause the tape at the
starting point of the dub.
Simultaneously, press PAUSE on
both units to begin dubbing.
3,4,5 6
_, 3, 4 /PAUSE Button Press STOP on the recording
E)STOP\PLAY Button/j_ unit, and then press STOP on the
Button_ L _ playing unit to end dubbing.
4REc
_ Button
• When two Palmcorders are used for
dubbing, it is recommended that the
remote control VCR1 or VCR2 setting be
used to avoid improper-operation.
• When two Palmcorders are connected
using the DV mterface cable (i.LINK) (not
_,.,_ supplied), a Video Editing Controller
cannot be used.
• Do not connect both an S-Video Cable or
A/V Cable and a DV Interface Cable
Button (i.LINK)
3,4,s C.UT,O. I
| Unauthorized exchangmg and/or copying of
PLAY I copynghted recordings may be copyright
ButtonPAUSE ._ _.._ , Button t infnngement
52
Loading ...
Loading ...
Loading ...