Loading ...
Loading ...
Loading ...
You can control any two Panasonic
Palmcorders with one Remote control
(Optional, page 64). In order for the remote
to distinguish between the two units, it Es
necessary to set one of the Palmcorders to
VCR 2. On the remote, press VCR 1 or
VCR 2 to control the desired Palmcorder.
i[._l
For VCR 2 :
Press these
buttons at the
same time.
same time.
1
2
3
For VCR 1 :
•Press these AI
buttons at the
=.1,
• When the Palmcorder and remote are
not set to the same mode (VCR1 or
VCR2), "CHECK REMOTE MODE
(REMOTE)" will appear.
REMOTE
Set the POWER to VCR or CAMERA.
• The POWER Lamp hghts red.
• Be sure POWER is fully turned to
VCR or CAMERA position.
Press MENU to display the VCR or
CAMERA mode menu screen.
Rotate JOG KEY to select_
in the CAMERA m_
screen or in the
VCR menu screen, press
JOG KEY to display the CAMERA
SET-UP or VCR PLAY MODE menu
screen.
Rotate JOG KEY to selectS,
and thenpress JOG KEY to select
VCR 2. (See pages 16, 17). Leave the
other Palmcorder set to VCRI.
Set the Remote Control (Optional,
page 64) to VCR 1 or VCR 2 to
correspond wtth the Palmcorder you
w_sh to control. (See above left.)
• After replacmg the Remote Control
Battery, the remote will default to VCR 1.
26
I
Insert a slender pointed object, such as the tip of a ball-
point pen into the slot so that it fits into the hole (as shown
A). Then, while sliding to the right, pull the Battery Tray
out with your fingernail•
Insert the battery into the Battery Tray wtth the G mark
facing down.
Do not reverse the polarity.
Insert the Battery Tray.
Replace battery wtth Panason_c PART NO VSBW0004 (CR2025)
only. Use of another battery may present a risk of fire or explosion l
Caution: battery may explode if mtstreated. Dtspose of used battery l
properly. Keep away from chddren Do not recharge, d_sassemble or|
dtspose of _nfire.
Loading ...
Loading ...
Loading ...