Loading ...
Loading ...
Loading ...
Remove the lens cap and clip it to the hand
strap.
t
Clip here
POWER ZOOM Switch
Vision
Adjustmenl
Control
POWER
Switch
Lamp
3REC/PA'USE Button
WARNING:
• Do not leave the Palmcorder with the
EVF aimed directly at the sun as this
may cause damage to the internal parts
of the EVF.
• Do not lift, or carry, the Palmcorder by
the EVF or the LCD Monitor.
Before you begin
• Connect the Palmcorder to a power |
• source. (See pages 11, 12.) |
Insert a cassette with record tab closed.[
(See page 6.) J
Set POWER to CAMERA.
• The POWER Lamp lights red.
• Be sure POWER is fully turned to
CAMERA position. EVF
I -1
REC/PAUSE mode
2
3
With the Viewfinder Eye Cup up to
your eye, adjust the Vision
Adjustment Control to your eyesight.
(See page 9,)
Press REC/PAUSE to start recording.
• "REC" is displayed on the screen.
Press REC/PAUSE again to pause
recording.
• To reduce microphone wind noise,
set the WIND-CUT to ON. (See
WIND- CUT on page 15.)
• When the Palmcorder is aimed at
excessively bright objects, or bright lights,
a vertical bar may appear in the p=cture.
This is a normal characteristic of the CCD
pick-up device. Try to avoid this whenever
possible.
To conserve power
fter 5 minutes, the Record/Pause mode
ill automatically change to Standby mode.
o resume recording, set POWER to OFF
nd then ON again.
You can gradually zoom in for close ups or zoom out for wide angle shots.
Zoom slowly : by lightly pressing the 'q" (Telephoto) or the "W" (Wide Angle) side of the
POWER ZOOM Sw=tch.
Zoom quickly : by applying more pressure.
_EFJF_
• The zooming speed ranges from a slow 22 seconds to a fast 2 seconds according
to the amount of pressure apphed to the POWER ZOOM Switch.
22
Loading ...
Loading ...
Loading ...