Loading ...
Loading ...
Loading ...
5PAUSE
Button
To listen to the desired audio sound, set
the AUDIO setting of the VCR mode MENU
(see page 17) as follows:
AUDIO:The following selections are
available for 12 bit AUDIO dubbed
recordings only (sound recorded in SP
mode only).
ST 1
ST 2
MIX
Set this position to listen to the
original sound.
Set this position to listen to the
audio dubbed sound.
Set this position to listen to both
the original sound and the audio
dubbed sound.
• 16 bit dubbed sound completely erases
the original 16 bit recorded sound.
• If you dubbed using 12 bit AUDIO
recording and then selected AUDIO-MIX
in the menu for playback, the sound will
be stereo regardless of the AUDIO-OUT
setting.
• If you recorded in LP mode, you cannot
use the A.DUB feature.
You can set an automatic Dubbing stop
point.
Press PAUSE to start Audio Dubbing.
• Connect the Palmcorder to the TV in
order to monitor the sound.
(See page 31 .)
INCOMPATIBLETAPE ]
Only NTSC (National Television Standards
Committee) recorded tapes can be audio
dubbed. The following screen appears if
the tape was not recorded in NTSC format.
Press PAUSE to stop Audio Dubbing.
• If the microphone used for dubbing gets
too near the speaker of your TV,
a howling noise (feedback) may occur.
• If the tape position is in or was started in
in a blank section, you cannot use the
A.DUB feature.
5O
DRESET_
Bu_on
AMENU /
Bu_on
A Press MENU to display the VCR
menu screen.
B Rotate JOG KEY to select[_
_, and then press JOG KEY
to d_splay the DISPLAY SETTING
menu.
C Rotate JOG KEY to selectS,
and then press JOG KEY to set to
MEMORY.
D Press MENU two times to ex=t MENU
mode. Then, press RESET on the
remote control to reset the Counter
Memory to M 0:00:00.
Now, rewind to the editing start point,
and continue with steps 2-5. The tape wdl
now stop automatically at "M 0:00:00".
Loading ...
Loading ...
Loading ...