Loading ...
Loading ...
Loading ...
Saw Operations - 2
Problem Probable Cause
What to Do
Workpiece kerf rough
with tooth marks from
blade (also called heel).
Saw blade not square
to fence.
Go to Alignment of the Blade,
Squaring Blade to Fence.
Saw blade not parallel
to table.
Go to Alignment of the Blade,
Making Blade Parallel to Table.
Using improper blade for finish
cut desired.
Use proper smooth cutting
blade.
Wood binds, smokes, and
motor slows down or stops
when ripping.
Dull blade or warped board. Sharpen or replace the saw
blade. Do not use severely
warped material.
Feed rate too fast. Slow feed rate.
Saw blade heels. Go to Alignment of the Blade,
Fence not straight. Replace fence.
Carriage assembly loose on arm. Go to Alignment of the Blade,
Squaring Blade to Table for Rip-
ping.
Board pulls away from
fence when ripping.
Workpiece strikes
spreader when ripping.
Saw does not travel
smoothly on arm.
Clamping force not suffi-
cient at miter angles other
than 45 ° .
Saw blade has heel.
Spreader not in line with blade.
Dirty track.
Bad bearing.
Worn track.
Miter lock needs adjustment.
Go to Alignment of the Blade,
Go to Alignment of the Blade,
Installing Guard / Setting
Spreader.
Clean track and lubricate with
light grease.
Replace bearing.
Replace track.
Go to Maintaining Your Saw,
Adjustments for Wear, Miter
Lock.
74
Loading ...
Loading ...
Loading ...