Loading ...
Loading ...
Loading ...
If the blade tried to "walk" on the square,
tighten the top left screw to move the arm to
the right. Then tighten the top right screw to
meet the column. Go to step 14.
14. Move the motor back and forth along the
radial arm. Repeat step 13 until the marked
tooth just touches the square at all points.
Then go to step 15.
15. Tighten the bottom screws in the front of
the column support, switching from right to
left several times so that you do not force the
radial arm out of line. Do not overtighten or
it will be difficult to raise and lower the
radial arm.
Fig. 62
12. Use a 1/8" hex "L"wrench to loosen the
four screws in the front of the column support
slightly, if you have not already done so in the
Adjusting Elevation section. (Figure 63)
Four Socket
_ / LL_ ,d_ Head Screws
...........................i _LT__L___ __-
Fig. 63 _-----___
13. Use the top two screws to move the
radial arm into line:
If the blade moved away from the square,
tighten the top right screw to move the arm to
the left. Then tighten the top left screw to
meet the column. Go to step 14, or
16. Raise and lower the radial arm. If this is
difficult, loosen the four screws in the front
of the column support slightly and try again.
Loosen all of these screws the same amount
so that you do not force the radial arm out of
line.
17. Repeat step 16 until movement of the
radial arm is smooth but firm. Then go to
step ! 8.
18. Lay a framing square on the front table
with the long edge along the back of the table
and the short edge alongside the blade, as
before.
19. Move the framing square toward the
blade, and rotate the blade with your hand,
until the marked tooth of the blade just
touches the edge of the square.
20. Move the motor back and forth along the
radial arm. Do not move the square.
21. If the marked tooth just touches the edge
of the square at all points, go to step 22, or
If the marked tooth moves away from the
edge of the square or tries to "walk" on top
of it, go back to step 13 and repeat.
28
Loading ...
Loading ...
Loading ...