Loading ...
Loading ...
Loading ...
*Recommended Accessories
Item Cat. No.
Saw blades
(10" diameter with 5/8" hole) See Catalog
Caster 9-22254
Sanding Drum 9-25246
Drill Chuck and Key 9-2980
Dust Collector See Catalog
Molding Head Guard 8" 9-29523
Taper Jig 9-3233
Auxiliary Table Cover See Catalog
Miter Square 9-32056
Pin Router 9-32765
Extension Table 9-32787
Satin Cut Dado
7" 9-3257
8" 9-3253
8" Carbide 9-3264
Standard Cut Dado
8" 9-32475
Adjustable Dado
7"-24 Tooth Carbide 9-3261
7"-32 Tooth Carbide 9-3262
7"-16 Tooth Carbide 9-3263
8"-48 Tooth Carbide 9-32708
Molding Heads
7"-Bits Not Included 9-3214
7"-27 Piece Set 9-3217
7"-15 Piece Set 9-3218
Sanding Wheel-10" 9-22723
Blade Stabilizer 9-2952
Cabinet Acessories
Shelf 9-22251
Door 9-22252
3 Drawer Set 9-22253
Books
PowerTool KnowHow Handbook See Catalog
Guards
Lower Retractable Guard 9-29009
(For 90° Crosscut Only)
* Recommended means that these accessories
are designed to fit this radial arm saw. Read and
follow accessory instructions on their use and
limitations.
Lower Retractable Guard
A lower retractable guard which meets
OSHA requirements for occupational use
of the radial saw is available. (See Note)
The lower guard is designed to provide
protection from contact with the fiat sides
of the blade when the radial saw is in the
90 ° crosscut position and in its rearmost
position behind the fence. The lower
guard only provides protection against
minor laceraUons and bruises.
_WARNING: The lower guard does
not provide protection during actual
crosscutting or ripping, or from con-
tact in line with or at an angle to the
saw blade teeth. When in the cut, the
inner and outer guards ride on top of
the fence or workpiece exposing the
saw blade teeth. Fingers, hands or
arm can be cut off if the saw blade is
contacted. Additional hazards are ex-
plained in the instructions accompan-
ing the lower blade guard.
_lb WARNING: The lower blade
guard can get caught or jammed in
fence and table kerfs, jam while set-
ting up for and while making bevel
and compound miter cuts and jam
during certain in-rip cuts. The
workpiece or narrow cut-off pieces
could kickback causing your hands
to be cut by the blade. Use the
lower retractable guard in the 90 °
crosscut position only.
WARNING:
TO AVOID INJURY
SHUT OFF POWER
BEFORE CLEARING A
JAMMED LOWER GUARD
Fig. 127Lower Guard Label
Note: Employers are required to provide the
lower retractable guard unless OSHA grants an
exemption. This saw is designed for use in non-
commercial settings.
61
Loading ...
Loading ...
Loading ...