Loading ...
Loading ...
Loading ...
Attaching Trim Ledge and
Trim Caps
1. Hold the trim ledge against the front of the
saw.
2. Reach through the top of the saw and use
four screws to fasten the trim ledge in place.
Tighten using a Phillips screwdriver.
(Figures 28 & 29)
Trim Ledge
Fig. 28
Fig. 29 - Phillips Head Screws
3. Hold the right trim cap in place on the
front right side of the cabinet. (Figure 30)
Fig. 30
Trim Cap
4. Reach through the top of the saw and use
two screws to hold the trim cap in place.
Tighten using a Phillips screwdriver.
5. Repeat steps 3-4 with the left trim cap.
Mounting Table Locks
The following parts are used in mounting the
table locks:
A°
B.
C.
D.
E.
F.
G.
H.
I.
J.
Lock Handles with Rods ........... 2
Right Table Rail .................. 1
Left Table Rail ................... 1
Hex Head Bolts 1/4-20x5/8 ......... 4
Lockwashers 1/4 .................. 4
Pan Head Screws 1/4x1-1/4 ......... 4
Hex Nuts 1/4-20 .................. 2
Washer 17/64 x 9/16 x 3/64 ......... 4
Locknuts 1/4-20 ................... 2
Slide Button ...................... 2
A
B,C D
E
Fig. 31- Parts for Table Locks
1. Put a lockwasher on a hex head bolt.
(Figure 32)
Fig. 32 - Lockwasher, Hex Nut, and Hex Head Bolt
2. Lift a lock handle and put the bolt through
the hole in the mounting plate as shown.
(Figure 33)
15
Loading ...
Loading ...
Loading ...