Loading ...
Loading ...
Loading ...
9. Hold the motor tightly and lock the bevel
lock. Do not let the motor move out of place.
10. Check the square to make sure that it is
still flush with the blade.
11. Tighten the four screws behind the yoke.
12. Raise the radial arm until the blade is
1-1/2 inches above the table.
13. Unlock the bevel lock and move the motor
to the 45 ° bevel position. (Figure 68)
_, CAUTION: The motor is heavy and
can swing down quickly. You can be cut
or injured if the blade hits you. Hold the
motor when you unlock the bevel lock.
If there is a gap between the square and the
blade after any rotation, go back to step 6 and
repeat.
19. Install bevel scale indicator by inserting
one end into the opening in the yoke. Slide the
indicator to one side and push until it snaps in
place. Tabs are located on the outside of the
opening. Adjust indicator by sliding red line
to 0 ° position. (Figure 69)
Fig. 69
Fig. 68
14. Move the motor back to the 0° bevel posi-
tion and lock the bevel lock.
15. Lower the radial arm until the blade is
just above the table.
16. Place the long edge of the framing square
on the table and the short edge against the
blade as before. Make sure the square is
against the surface of the blade and not the
set of a tooth.
Squaring Blade to Fence
These steps are done so that your blade will
be perpendicular to the fence. This will help
reduce the risk of kickback when ripping, and
splintering of the workpiece and burning of
the kerf when ripping and crosscutting.
Fig. 70 - Squaring Blade to Fence
1. Put the radial arm in the 0° miter position
with the blade just in front of the fence.
(Figure 70)
2. Lock the rip lock.
17. Turn the blade with your hand several
times and check to see if the square is flush
with the blade.
18. if the square is flush with the blade after
each rotation, go to Step 19, or
3. Place the framing square with the long
edge against both the fence and the table, and
the short edge against the bla&, just above
the arborsh@. Make sure that the edge of
the square is on the blade and not on the set
of a tooth. (Figure 70)
30
Loading ...
Loading ...
Loading ...