Loading ...
Loading ...
Loading ...
68 GETTING TO KNOW YOUR VEHICLE
NOTE:
• The multifunction lever must be in the high beam position
in order to activate the Automatic High Beams.
• The Automatic High Beam Headlamp Control can be
turned on or off using the Uconnect System. Refer to
“Uconnect Settings” in “Multimedia” for further informa-
tion.
• Broken, muddy, or obstructed headlights and taillights of
vehicles in the field of view will cause headlights to remain
on longer (closer to the vehicle). Also, dirt, film, and other
obstructions on the windshield or camera lens will cause
the system to function improperly.
When set to AUTO, the system automatically turns the head-
lights on or off based on ambient light levels.
Flash-To-Pass
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This will
cause the high beam headlights to turn on, and remain on,
until the lever is released.
Automatic Headlights — If Equipped
This system automatically turns the headlights on or off
according to ambient light levels. To turn the system on,
rotate the headlight switch clockwise to the last detent
(AUTO position) for automatic headlight operation. When
the system is on, the headlight time delay feature is also on.
This means the headlights will stay on for up to 90 seconds
after you cycle the ignition to OFF. To turn the automatic
system off, move the headlight switch out of the AUTO posi-
tion.
NOTE:
The engine must be running before the headlights will come
on in the automatic mode.
Parking Lights
Rotate the headlight switch clockwise to the first detent for
parking light and instrument panel light operation. Rotate
the headlight switch to the second detent for headlight,
parking light and instrument panel light operation.
2020_JEEP_CHEROKEE_OM_USA=GUID-B9F8E23F-10A5-4D6C-A585-BCFF41CCB747=1=en=.book Page 68
Loading ...
Loading ...
Loading ...