Loading ...
Loading ...
Loading ...
IN CASE OF EMERGENCY 423
is in the Sealant Mode position and not Air Mode. Push
the Power Button to turn On the Tire Service Kit.
2. Connect the Power Plug to a different 12 Volt power
outlet in your vehicle or another vehicle, if available.
Make sure the engine is running before turning ON the
Tire Service Kit.
3. The Sealant Bottle may be empty due to previous use.
Call for assistance.
NOTE:
If the Mode Select Knob is on Air Mode and the pump is
operating, air will dispense from the Air Pump Hose only,
not the Sealant Hose.
If the sealant (white fluid) does flow through the Sealant
Hose:
1. Continue to operate the pump until sealant is no longer
flowing through the hose (typically takes 30 - 70
seconds). As the sealant flows through the Sealant Hose,
the Pressure Gauge can read as high as 70 psi (4.8 Bar).
The Pressure Gauge will decrease quickly from approx-
imately 70 psi (4.8 Bar) to the actual tire pressure when
the Sealant Bottle is empty.
2. The pump will start to inject air into the tire immediately
after the Sealant Bottle is empty. Continue to operate the
pump and inflate the tire to the pressure indicated on the
tire pressure label on the driver-side latch pillar (recom-
mended pressure). Check the tire pressure by looking at
the Pressure Gauge.
If the tire does not inflate to at least 26 psi (1.8 Bar) pressure
within 15 minutes:
NOTE:
Never operate the compressor for longer than 20 minutes.
Risk of Overheating.
• The tire is too badly damaged. Do not attempt to drive the
vehicle further. Call for assistance.
NOTE:
If the tire becomes overinflated, push the Deflation Button to
reduce the tire pressure to the recommended inflation pres-
sure before continuing.
6
2020_JEEP_CHEROKEE_OM_USA=GUID-B9F8E23F-10A5-4D6C-A585-BCFF41CCB747=1=en=.book Page 423
Loading ...
Loading ...
Loading ...