Loading ...
Loading ...
Loading ...
424 IN CASE OF EMERGENCY
If the tire inflates to the recommended pressure or is at
least 26 psi (1.8 Bar) pressure within 15 minutes:
1. Push the Power Button to turn off the Tire Service Kit.
2. Remove the Speed Limit sticker from the top of the
Sealant Bottle and place the sticker on the instrument
panel.
3. Immediately disconnect the Sealant Hose from the valve
stem, reinstall the cap on the fitting at the end of the hose,
and place the Tire Service Kit in the vehicle storage loca-
tion. Quickly proceed to “Drive Vehicle.”
(D) Drive Vehicle:
Immediately after injecting sealant and inflating the tire,
drive the vehicle 5 miles (8 km) or 10 minutes to ensure
distribution of the Tire Service Kit Sealant within the tire. Do
not exceed 50 mph (80 km/h).
(E) After Driving:
Pull over to a safe location. “Refer to “(A) Whenever You
Stop To Use Tire Service Kit” in this section, before
continuing.”
1. Push in the Mode Select Knob and turn to the Air Mode
position.
2. Uncoil the power plug and insert the plug into the
vehicle's 12 Volt power outlet.
CAUTION!
• The metal end fitting from Power Plug may get hot
after use, so it should be handled carefully.
• Failure to reinstall the cap on the fitting at the end of
the Sealant Hose can result in sealant contacting your
skin, clothing, and the vehicle’s interior. It can also
result in sealant contacting internal Tire Service Kit
components which may cause permanent damage to
the kit.
WARNING!
Tire Service Kit is not a permanent flat tire repair. Have
the tire inspected and repaired or replaced after using
Tire Service Kit. Do not exceed 50 mph (80 km/h) until
the tire is repaired or replaced. Failure to follow this
warning can result in injuries that are serious or fatal to
you, your passengers, and others around you.
2020_JEEP_CHEROKEE_OM_USA=GUID-B9F8E23F-10A5-4D6C-A585-BCFF41CCB747=1=en=.book Page 424
Loading ...
Loading ...
Loading ...