Loading ...
Loading ...
Loading ...
IN CASE OF EMERGENCY 425
3. Uncoil the Air Pump Hose (black in color) and screw the
fitting at the end of hose onto the valve stem.
4. Check the pressure in the tire by reading the Pressure
Gauge.
If tire pressure is less than 19 psi (1.3 Bar):
The tire is too badly damaged. Do not attempt to drive the
vehicle further. Call for assistance.
If the tire pressure is 19 psi (1.3 Bar) or higher:
1. Push the Power Button to turn on Tire Service Kit and
inflate the tire to the pressure indicated on the tire and
loading information label on the driver-side door
opening.
NOTE:
If the tire becomes over-inflated, push the Deflation Button
to reduce the tire pressure to the recommended inflation
pressure before continuing.
2. Disconnect the Tire Service Kit from the valve stem, rein-
stall the cap on the valve stem and unplug from 12 Volt
outlet.
3. Place the Tire Service Kit in its proper storage area in the
vehicle.
4. Have the tire inspected and repaired or replaced at the
earliest opportunity at an authorized dealer or tire service
center.
5. Remove the Speed Limit sticker from the instrument
panel after the tire has been repaired.
6. Replace the Sealant Bottle and Sealant Hose assembly at
an authorized dealer as soon as possible. “Refer to
“Sealant Bottle And Hose Replacement” in this section for
further information.”
NOTE:
When having the tire serviced, advise the authorized dealer
or service center that the tire has been sealed using the Tire
Service Kit.
(F) Sealant Bottle And Hose Replacement:
1. Uncoil the Sealant Hose (clear in color).
2. Locate the red colored round Sealant Bottle release button
at the lower right hand corner of the kit.
3. Push and hold the Sealant Bottle release button, then pull
out the bottle holding the button.
4. Clean any remaining sealant from the Tire Service Kit
housing.
6
2020_JEEP_CHEROKEE_OM_USA=GUID-B9F8E23F-10A5-4D6C-A585-BCFF41CCB747=1=en=.book Page 425
Loading ...
Loading ...
Loading ...