Loading ...
Loading ...
Loading ...
30 GETTING TO KNOW YOUR VEHICLE
NOTE:
• If an engine fault is present or fuel level is low, the vehicle
will start and then shut down in 10 seconds.
• The parking lights will turn on and remain on during
Remote Start mode.
• For security, power window and power sunroof operation
(if equipped) are disabled when the vehicle is in the
Remote Start mode.
• The engine can be started two consecutive times with the
key fob. However, the ignition must be cycled by pushing
the START/STOP ignition button twice (or the ignition
switch must be cycled to the ON/RUN position) before
you can repeat the start sequence for a third cycle.
To Exit Remote Start Mode Without Driving The
Vehicle
Push and release the remote start button one time or allow
the engine to run for the entire 15-minute cycle.
NOTE:
To avoid unintentional shutdowns, the system will disable
with a one time push of the remote start button for two
seconds after receiving a valid remote start request.
To Exit Remote Start Mode And Drive The Vehicle
Before the end of 15-minute cycle, push and release the
unlock button on the key fob to unlock the doors and disarm
the vehicle security alarm (if equipped). Then, prior to the
end of the 15-minute cycle, push and release the START/
STOP ignition button. If the START/STOP ignition button is
not present, insert the key fob into the ignition switch and
turn the switch to the ON/RUN position.
NOTE:
For vehicles equipped with the Keyless Enter-N-Go —
Passive Entry feature, the message “Remote Start Active —
Push Start Button” will show in the instrument cluster
display until you push the START/STOP ignition button.
Remote Start Comfort Systems — If Equipped
When remote start is activated, the heated steering wheel
and driver heated seat feature will automatically turn on in
cold weather. In warm weather, the driver vented seat
feature will automatically turn on when the remote start is
activated. These features will stay on through the duration of
remote start or until the ignition switch is cycled to the ON/
RUN position.
2020_JEEP_CHEROKEE_OM_USA=GUID-B9F8E23F-10A5-4D6C-A585-BCFF41CCB747=1=en=.book Page 30
Loading ...
Loading ...
Loading ...