Loading ...
Loading ...
Loading ...
2. Connect the Power Plug to a different 12 Volt
power outlet in your vehicle or another vehicle, if
available. Make sure the vehicle is running be-
fore turning the Tire Service Kit on.
3. The Sealant Bottle may be empty due to previ-
ous use. Call for assistance.
If the sealant (white fluid) does flow through the
Sealant Hose:
1. Continue to operate the pump until sealant is no
longer f lowing through hose (typically takes 30 -
70 seconds). As the sealant flows through the
Sealant Hose, the Pressure Gauge can read as
high as 70 psi (4.8 Bar). The Pressure Gauge will
decrease quickly from approximately 70 psi
(4.8 Bar) to the actual tire pressure when the
Sealant Bottle is empty.
2. The pump will start to inject air into the tire
immediately after the Sealant Bottle is empty.
Continue to operate the pump and inflate the
tire to the cold tire inflation pressure found on
the tire and loading information label located in
the driver-side door opening. Check the tire
pressure by looking at the Pressure Gauge.
If the tire does not inflate to at least 26 psi
(1.8 Bar) pressure within 15 minutes:
• The tire is too badly damaged. Do not attempt to
drive the vehicle further. Call for assistance.
If the tire inflates to the recommended pressure
or is at least 26 psi (1.8 Bar) pressure within
15 minutes:
NOTE:
If the tire becomes over-inflated, push the Defla-
tion Button to reduce the tire pressure to the rec-
ommended inflation pressure before continuing.
1. Push the Power Button to turn the Tire Service
Kit off.
2. Remove the speed limit label from the Tire Ser-
vice Kit and place sticker on the steering wheel.
3. Immediately disconnect the Sealant Hose from
the valve stem, reinstall the cap on the fitting at
the end of the hose, and place the Tire Service
Kit in the vehicle storage location. Proceed to
“Drive Vehicle.”
Drive Vehicle:
Immediately after injecting sealant and inflating the
tire, drive the vehicle 5 miles (8 km) or 10 minutes to
ensure distribution of the Tire Service Kit Sealant
within the tire. Do not exceed 50 mph (80 km/h).
WARNING!
The Tire Service Kit is not a permanent flat tire
repair. Have the tire inspected and repaired or
replaced after using the Tire Service Kit. Do not
exceed 50 mph (80 km/h) until the tire is re-
paired or replaced. Failure to follow this warning
can result in injuries that are serious or fatal to
you, your passengers, and others around you.
Have the tire checked as soon as possible at your
authorized dealer.
After Driving:
Pull over to a safe location. Refer to “Whenever You
Stop To Use Tire Service Kit” in this section before
continuing.
1. Uncoil the Sealant Hose, and then remove the
cap from the fitting at the end of the hose.
IN CASE OF EMERGENCY
182
Loading ...
Loading ...
Loading ...