Loading ...
Loading ...
Loading ...
• When the LaneSense system senses the lane has
been approached and is in a lane departure situa-
tion, the left inside lane line flashes yellow (on/off)
while the left outside line remains solid yellow. The
LaneSense telltale
changes from solid yellow
to flashing yellow. At this time torque is applied to
the steering wheel in the opposite direction of the
lane boundary.
For example: If approaching the left side of the lane
the steering wheel will turn to the right.
NOTE:
The LaneSense system operates with the similar
behavior for a right lane departure.
Changing LaneSense Status
The LaneSense system has settings to adjust the
intensity of the torque warning and the warning
zone sensitivity (Early/Medium/Late) that you can
configure through the Uconnect system screen. Re-
fer to “Uconnect Settings” in “Multimedia” in your
Owner’s Manual for further information.
NOTE:
• When enabled the system operates above 37 mph
(60 km/h) and below 112 mph (180 km/h).
• Use of the turn signal suppresses the warnings.
• The system will not apply torque to the steering
wheel whenever a safety system engages. (anti-
lock brakes, traction control system, electronic sta-
bility control, forward collision warning, etc.).
PARKVIEW REAR BACK
UP CAMERA
The ParkView Rear Back Up Camera allows you to
see an on-screen image of the rear surroundings of
your vehicle whenever the gear selector is put into
REVERSE. The image will be displayed on the
touchscreen display along with a caution note
“Check Entire Surroundings” across the top of the
screen. After five seconds, this note will disappear.
The ParkView Rear Back Up Camera is located on
the rear of the vehicle above the rear license plate.
NOTE:
The ParkView Rear Back Up Camera has program-
mable modes of operation that may be selected
through the Uconnect System. Refer to “Uconnect
Settings” in “Multimedia” in the Owner’s Manual for
further information.
When the vehicle is shifted out of REVERSE (with
camera delay turned off), the rear camera mode is
exited and the navigation or audio screen appears
again.
When the vehicle is shifted out of REVERSE (with
camera delay turned on), the camera image will
continue to be displayed for up to 10 seconds after
shifting out of REVERSE unless the vehicle speed
exceeds 8 mph (13 km/h), the vehicle is shifted into
PARK or the ignition is switched to the OFF posi-
tion.
A touch screen button to disable display of the
camera image is made available when the vehicle is
not in REVERSE gear. Display of the camera image
after shifting out of REVERSE can be disabled via a
touch screen button personalization entry in the
camera settings menu.
When enabled, active guide lines are overlaid on
the image to illustrate the width of the vehicle and
its projected backup path based on the steering
wheel position.
Different colored zones indicate the distance to the
rear of the vehicle.
STARTING AND OPERATING
158
Loading ...
Loading ...
Loading ...