Loading ...
Loading ...
Loading ...
• The driver must stay in full control of the vehicle's
acceleration and braking and is responsible for the
vehicle's movements.
Refer to “ParkSense System Usage Precautions” for
limitations of this system and recommendations.
ParkSense will retain the last system state (enabled
or disabled) from the last ignition cycle when the
ignition is changed to the ON/RUN position.
ParkSense can be active only when the gear selector
is in REVERSE. If ParkSense is enabled at this gear
selector position, the system will remain active until
the vehicle speed is increased to approximately
7 mph (11 km/h) or above. When in REVERSE and
above the system's operating speed, a warning will
appear within the instrument cluster display indicat-
ing the vehicle speed is too fast. The system will
become active again if the vehicle speed is de-
creased to speeds less than approximately 6 mph
(9 km/h).
ParkSense Sensors
The four ParkSense sensors, located in the rear
fascia/bumper, monitor the area behind the vehicle
that is within the sensors’ field of view. The sensors
can detect obstacles from approximately 12 inches
(30 cm) up to 79 inches (200 cm) from the rear
fascia/bumper in the horizontal direction, depend-
ing on the location, t ype and orientation of the
obstacle.
ParkSense Visual Alert
The ParkSense Warning screen will only be dis-
played if Sound and Display is selected from the
Customer - Programmable Features section of the
Uconnect System. Refer to “Uconnect Settings” in
“Multimedia” in your Owner’s Manual for further
information.
The ParkSense Warning screen is located within the
instrument cluster display. It provides visual warn-
ings to indicate the distance between the rear
fascia/bumper and the detected obstacle. Refer to
“Instrument Cluster Display” in “Getting To Know
Your Instrument Panel” in your Owner’s Manual for
further information.
Enabling And Disabling ParkSense
ParkSense can be enabled and disabled
with the ParkSense switch, located on
the switch panel below the Uconnect
display.
When the ParkSense switch is pushed to disable the
system, the instrument cluster will display the
“PARKSENSE OFF” message for approximately
five seconds. Refer to “Instrument Cluster Display”
in “Getting To Know Your Instrument Panel” in your
Owner’s Manual for further information. When the
gear selector is moved to REVERSE and the system
is disabled, the instrument cluster display will show
the “PARKSENSE OFF” message for as long as the
vehicle is in REVERSE.
The ParkSense switch LED will be on when
ParkSense is disabled or requires service. The
ParkSense switch LED will be off when the system is
enabled. If the ParkSense switch is pushed, and
requires service, the ParkSense switch LED will blink
momentarily, and then the LED will be on.
STARTING AND OPERATING
152
Loading ...
Loading ...
Loading ...