Loading ...
Loading ...
Loading ...
NOTE:
If snow, ice, mud, or any foreign substance builds up
on the camera lens, clean the lens, rinse with water,
and dry with a soft cloth. Do not cover the lens.
WARNING!
Drivers must be careful when backing up even
when using the ParkView Rear Back Up Camera.
Always check carefully behind your vehicle, and
be sure to check for pedestrians, animals, other
vehicles, obstructions, or blind spots before
backing up. You are responsible for the safety of
your surroundings and must continue to pay at-
tention while backing up. Failure to do so can
result in serious injury or death.
CAUTION!
• To avoid vehicle damage, ParkView should
only be used as a parking aid. The ParkView
camera is unable to view every obstacle or
object in your drive path.
• To avoid vehicle damage, the vehicle must be
driven slowly when using ParkView to be able
to stop in time when an obstacle is seen. It is
CAUTION!
recommended that the driver look frequently
over his/her shoulder when using ParkView.
SURROUND VIEW
CAMERA SYSTEM —
IF EQUIPPED
Your vehicle may be equipped with the Surround
View Camera System that allows you to see an
on-screen image of the surroundings and top view
of your vehicle whenever the gear selector is put
into REVERSE or a different view is selected
through the "on screen soft buttons". The top view
of the vehicle will show which doors are open. The
image will be displayed on the touchscreen display
along with a caution note “Check Entire Surround-
ings” across the top of the screen. After five sec-
onds, this note will disappear. The Surround View
Camera System is comprised of four sequential
cameras located in the front grille, rear liftgate and
side mirrors.
NOTE:
The Surround View Camera System has program-
mable settings that may be selected through the
Uconnect System. Refer to “Uconnect Settings” in
“Multimedia” in the Owner’s Manual for further
information.
When the vehicle is shifted into REVERSE, the rear
camera view and top view is the default view of the
system.
When the vehicle is shifted out of REVERSE (with
camera delay turned on), the camera image will
continue to be displayed for up to 10 seconds after
shifting out of REVERSE unless the vehicle speed
exceeds 8 mph (13 km/h), the vehicle is shifted into
PARK or the ignition is switched to the OFF posi-
tion. There is a touch screen button (X ) to disable
the display of the camera image.
When the vehicle is shifted out of REVERSE (with
camera delay turned off), the surround view camera
mode is exited and the last known screen appears
again.
When enabled, active guide lines are overlaid on
the image to illustrate the width of the vehicle,
including the side view mirrors and its projected
backup path based on the steering wheel position.
159
Loading ...
Loading ...
Loading ...