Loading ...
Loading ...
Loading ...
CAUTION!
cated above or below the sensors will not be
detected when they are in close proximity.
• The vehicle must be driven slowly when using
ParkSense in order to be able to stop in time
when an obstacle is detected. It is recom-
mended that the driver looks over his/her
shoulder when using ParkSense.
PARKSENSE FRONT AND
REAR PARK ASSIST — IF
EQUIPPED
The ParkSense Park Assist system provides visual
and audible indications of the distance between the
rear and/or front fascia and a detected obstacle
when backing up or moving forward, e.g. during a
parking maneuver. If your vehicle is equipped with
an automatic transmission, the vehicle brakes may
be automatically applied and released when per-
forming a reverse parking maneuver if the system
detects a possible collision with an obstacle.
NOTE:
• The driver can override the automatic braking
function by pressing the gas pedal, turning
ParkSense off via ParkSense switch, or changing
the gear while the automatic brakes are being
applied.
• Automatic brakes will not be available if ESC is not
available.
• Automatic brakes will not be available if there is a
faulted condition detected with the ParkSense
Park Assist system or the Braking System Module.
• The automatic braking function may not provide
enough vehicle deceleration to avoid colliding
with a detected obstacle depending on vehicle
speed, road conditions, and brake capability.
• The automatic braking function may not be ap-
plied fast enough for moving obstacles that ap-
proach the rear of the vehicle from the left and / or
right sides.
• The automatic braking function can be enabled/
disabled from the Customer-Programmable Fea-
tures section of the Uconnect System.
• ParkSense will retain its last known configuration
state for the automatic braking function through
ignition cycles.
The automatic braking function is intended to assist
the driver in avoiding possible collisions with de-
tected obstacles when backing up in REVERSE
gear.
NOTE:
• The driver is always responsible for controlling the
vehicle.
• The system is provided to assist the driver and not
to substitute the driver.
• The driver must stay in full control of the vehicle's
acceleration and braking and is responsible for the
vehicle's movements.
Refer to “ParkSense System Usage Precautions” in
“Starting And Operating” in your Owner’s Manual
for limitations of this system and recommendations.
ParkSense will retain the last system state (enabled
or disabled) from the last ignition cycle when the
ignition is changed to the ON/RUN position.
ParkSense can be active only when the gear selector
is in REVERSE or DRIVE.If ParkSense is enabled at
one of these gear selector positions, the system will
remain active until the vehicle speed is increased to
approximately 7 mph (11 km/h) or above. When in
REVERSE and above the system's operating
STARTING AND OPERATING
154
Loading ...
Loading ...
Loading ...