Loading ...
Loading ...
Loading ...
uled time and day of the week. If a charging
schedule has been enabled in the vehicle, and
it is outside the time and day of the week, you
may override the schedule for this charging
event by plugging in the charge connector,
unplugging it, and then plugging it back into
the vehicle charge inlet. Complete the double
plug sequence within ten seconds for it to
override the set schedule.
5. To stop the charging process, disconnect the
vehicle side connector first and then the charg-
ing cordset from the wall receptacle. To disen-
gage the vehicle coupler, press the button on the
charge connector first and then remove the con-
nector from the vehicle charge inlet.
6. Close the inlet door when an EVSE is not con-
nected to the vehicle.
NOTE:
It is good practice to keep the ignition in the OFF
position while conducting Level 1 Charging. This
minimizes any additional vehicle loads the EVSE
has to support. The additional electrical loads will
extent the High Voltage Battery charging time.
AC Level 2 Charging (240V, 30 Amp
Or 32 Amp)
AC Level 2 (240 V) charging requires a 240 V, Level
2 EVSE (Charging station). A 30 Amp or 32 Amp
Level 2 EVSE for home installation is recom-
mended.
When using public charging stations, ensure the
charging station is ready to provide charge and the
vehicle is in PARK before the charge connector is
plugged into the vehicle’s charge inlet. You will hear
a “click” when the charge connector is inserted cor-
rectly and is coupled with the vehicle’s charge inlet.
The vehicle should start charging automatically. If
not, please check the instructions at the charging
station.
NOTE:
The vehicle should start charging automatically. If
not, please check the following:
• Charging Station – Check the indications and in-
structions at the charging station or
• Charging Schedule – Check whether the charging
schedule is enabled and if so, whether the vehicle is
currently within the scheduled charge time/day
(weekday/weekend). If the charging schedule is
enabled within the vehicle, you may override them
for this charging event by plugging in the charge
connector, unplugging it, and then plugging it
back into the vehicle charge inlet. Complete the
double plug sequence within ten seconds for it to
override the set schedule.
To stop the charging process:
• Press the “STOP” button located on the front of
the EVSE station.
• Press the button on the charge connector first and
then remove the connector from the vehicle
charge inlet.
• Plug the charge handle into the EVSE station and
coil the charging cord onto its holder. Do not leave
the charging cord laying on the ground.
Charging Times
The following factors determine the time it takes to
charge the high voltage battery:
• The high voltage battery’s current state of charge
• The type of EVSE used (Level 1 - 120V or Level 2
– 240V)
• Ambient temperature
• Whether the vehicle is ON during charging
13
Loading ...
Loading ...
Loading ...