Loading ...
Loading ...
Loading ...
FUSES
WARNING!
• When replacing a blown fuse, always use an
appropriate replacement fuse with the same
amp rating as the original fuse. Never replace
a fuse with another fuse of higher amp rating.
Never replace a blown fuse with metal wires or
any other material. Do not place a fuse inside
a circuit breaker cavity or vice versa. Failure to
use proper fuses may result in serious personal
injury, fire and/or property damage.
• Before replacing a fuse, make sure that the
ignition is off and that all the other services are
switched off and/or disengaged.
WARNING!
• If the replaced fuse blows again, contact an
authorized dealer.
• If a general protection fuse for safety systems
(air bag system, braking system), power unit
systems (engine system, transmission system)
or steering system blows, contact an autho-
rized dealer.
Underhood Fuses
The Power Distribution Center is located in the
engine compartment near the battery. This center
contains cartridge fuses, mini-fuses, micro-fuses,
circuit breakers and relays. A label that identifies
each component is printed on the inside of the
cover.
Before any procedure is done on the PDC, make
sure engine is turned off.
Remove the cover by unlatching the two locks lo-
cated at each side of the PDC cover, avoid the
usage of screw drivers or any other tool to remove
the cover, since they may apply excessive force and
result on a broken/damaged part.
After service is done, secure the cover with its two
locks.
Cavity Cartridge Fuse Blade Fuse Description
F06 – 15 Amp Blue Low Temp Active Pump
F07 – 25 Amp Clear Ignition Coil/Fuel Injector
F08 – 25 Amp Clear Amplifier / Active Noise Control
F09 – – Not Used
F10 – 15 Amp Blue High Temp Aux Pump & HV Electric Coolant Htr Enable
F11 – 15 Amp Blue ELCM / FTIV
F12 – 5 Amp Tan Battery Sensor (IBS)
IN CASE OF EMERGENCY
168
Loading ...
Loading ...
Loading ...