Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE
70
Canadian radio frequency laws require trans-
mitter signals to time-out (or quit) after
se
veral seconds of transmission – which may
not be long enough for HomeLink® to pick
up the signal during programming. Similar to
this Canadian law, some U.S. gate operators
are designed to time-out in the same
manner.
It may be helpful to unplug the device during
th
e cycling process to prevent possible over-
heating of the garage door or gate motor.
1. P
lace the ignition in the ON position.
2
. Place the hand-held transmitter 1 to
3
inches (3 to 8 cm) away from the
Ho
meLink® button you wish to program
while keeping the HomeLink® indicator
light in view.
3. Continue to press and hold the Home-
L
ink® button, while you press and
re
lease (cycle) your hand-held trans-
mitter every two seconds until Home-
Link® has successfully accepted the
f
r
equency signal. The indicator light will
flash slowly and then rapidly when fully
trained.
4. Watch for the HomeLink® indicator to
ch
ange flash rates. When it changes, it is
programmed. It may take up to 30 seconds
or longer in rare cases. The garage door
may open and close while you are program
-
ming.
5. P
ress and hold the programmed Home-
L
ink® button and observe the indicator
li
ght.
NOTE:
If the indicator light stays on constantly,
programming is complete and the garage
door/device should activate when the
HomeLink® button is pressed.
To program the two remaining HomeLink®
buttons, repeat each step for each
remaining button. DO NOT erase the chan
-
nels.
If you unplugged the garage door opener/
de
vice for programming, plug it back in at
this time.
Reprogramming A Single HomeLink® Button
(C
anadian/Gate Operator)
To reprogram a channel that has been previ-
ously trained, follow these steps:
1. P
lace the ignition to the ON position.
2
. Press and hold the desired HomeLink®
b
utton until the indicator light begins to
flash after 20 seconds. Do not release
the button.
3. Without releasing the button, proceed
w
ith “Canadian/Gate Operator Program-
ming” step 2 and follow all remaining
s
t
eps.
Using HomeLink®
To operate, push and release the
programmed HomeLink® button. Activation
will now occur for the programmed device
(i.e. garage door opener, gate operator, secu
-
rity system, entry door lock, home/office
li
ghting, etc.). The hand-held transmitter of
the device may also be used at any time.
Loading ...
Loading ...
Loading ...