Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE
68
To erase the channels, place the ignition in
the ON position, and push and hold the two
outside HomeLink® buttons (1 and 3) for up
to 20 seconds or until the orange indicator
flashes.
NOTE:
Erasing all channels should only be
performed when programming Home-
Link® for the first time. Do not erase
c
h
annels when programming additional
buttons.
If you have any problems, or require assis-
tance, please call toll-free
1-
800-355-3515 or, on the Internet at
HomeLink.com for information or assis-
tance.
Programming A Rolling Code
Garage door openers that were manufactured
after 1995 can be identified by the
“LEARN” or “TRAIN” button located where
the hanging antenna is attached to the
garage door opener.
NOTE:
It is NOT the button that is normally used to
op
en and close the door. The name and color
of the button may vary by manufacturer.
Training The Garage Door Opener
For programming these garage door openers,
pr
oceed as follows:
1. Place the ignition in the ON position.
2
. Place the hand-held transmitter 1 to
3
inches (3 to 8 cm) away from the
Ho
meLink® button you wish to program
while keeping the HomeLink® indicator
light in view.
3. Push and hold the HomeLink® button
y
ou want to program while you push and
hold the hand-held transmitter button.
4. Continue to hold both buttons and
o
bserve the indicator light. The Home-
Link® indicator will flash slowly and then
r
a
pidly after HomeLink® has received
the frequency signal from the hand-held
transmitter. Release both buttons after
the indicator light changes from slow to
rapid.
5. On the garage door opener (in the
g
arage), locate the “LEARN” or
“TRAINING” button. This can usually be
found where the hanging antenna wire is
attached to the garage door opener/
device motor. Firmly push and release
the “LEARN” or “TRAINING” button. On
some garage door openers/devices there
may be a light that blinks when the
garage door opener/device is in the
LEARN/TRAIN mode.
NOTE:
You have 30 seconds in which to initiate the
n
e
xt step after the LEARN button has been
pushed.
1 — Door Opener
2 — Training Button
Loading ...
Loading ...
Loading ...