Loading ...
Loading ...
Loading ...
129
NOTE:
Each tire pressure sensor has a unique ID
signal code. The signal code must be
registered with the TPMS before it can
work. The easiest way to do it is to have an
authorized dealer change your tire and
complete ID signal code registration.
When an authorized dealer changes your
vehicle's tires, they will complete the tire
pressure sensor ID signal code registra
-
tion.
If you or someone else changes tires, you or
so
meone else can also undertake the steps
for the TPMS to complete the ID signal code
registration:
After tires have been changed, place the
ignition in the ON mode, then back to ACC
or OFF modes.
Wait for about 15 minutes.
After about 15 minutes, drive the vehicle
at a speed of at least 16 mph (25 km/h)
fo
r 20 minutes and the tire pressure
se
nsor ID signal code will be registered
automatically.
NOTE:
If the vehicle is driven within about
15
minutes of changing tires, the warning
light will flash because the sensor ID signal
co
de would not have been registered. If this
happens, park the vehicle for about
15
minutes, after which the sensor ID signal
co
de will register upon driving the vehicle for
20
minutes.
Replacing Tires And Wheels
NOTE:
When replacing/repairing the tires or
wheels or both, have the work done by an
authorized dealer, or the tire pressure
sensors may be damaged.
The wheels equipped on your vehicle are
specially designed for installation of the
tire pressure sensors. Do not use
non-genuine wheels, otherwise it may not
be possible to install the tire pressure
sensors.
Be sure to have the tire pressure sensors
in
stalled whenever tires or wheels are
replaced.
When having a tire or wheel or both replaced,
th
e following types of tire pressure sensor
installations are possible:
The tire pressure sensor is removed from
the old wheel and installed to the new one.
The same tire pressure sensor is used with
the same wheel. Only the tire is replaced.
A new tire pressure sensor is installed to a
new wheel.
NOTE:
The tire pressure sensor ID signal code
must be registered when a new tire pres-
sure sensor is purchased. For purchase of
a
tire pressure sensor and registration of
the tire pressure sensor ID signal code,
consult an authorized dealer.
When reinstalling a previously removed
tire pressure sensor to a wheel, replace the
grommet (seal between valve body/sensor
and wheel) for the tire pressure sensor.
Loading ...
Loading ...
Loading ...