Loading ...
Loading ...
Loading ...
273
Do not drain the engine cooling system.
Any time the vehicle is left inactive for two
weeks or more, operate the air condi-
tioning system with engine idling for at
l
e
ast five minutes, setting external air and
with fan set to maximum speed. This oper
-
ation will ensure appropriate lubrication
fo
r the system, thus minimizing the possi-
bility of damage to the compressor when
t
h
e system is operated again.
NOTE:
After placing the ignition in the OFF mode
a
n
d having closed the driver side door, wait
at least one minute before disconnecting the
electrical supply from the battery. When
reconnecting the electrical supply to the
battery, make sure that the ignition in the
OFF mode and the driver side door is closed.
BODYWORK
Protection From Atmospheric Agents
The vehicle is equipped with the best avail-
able technological solutions to protect the
bo
dywork against corrosion.
These include:
Painting products and systems which give
the vehicle resistance to corrosion and
abrasion.
Use of galvanized (or pre-treated) steel
sheets, with high resistance to corrosion.
Spraying of plastic parts, with a protective
function in the more exposed points:
underdoor, inner fender, edges, etc.
Use of “open” boxed sections to prevent
condensation and pockets of moisture
which could favor the formation of rust
inside.
Use of special films to protect against
abrasion in exposed areas (e.g. rear
fender, doors, etc.).
Corrosion Warranty
Your vehicle is covered by a Corrosion
Warranty against perforation due to rust of
any original element of the structure or body
-
work. For the general terms of this Corrosion
Wa
rranty, refer to the Warranty Booklet.
Preserving The Paintwork
Touch up abrasions and scratches immedi-
ately to prevent the formation of rust.
Maintenance of paintwork consists of
wa
shing the vehicle: the frequency depends
on the conditions and environment in which
the vehicle is used.
For example, it is advisable to wash the
ve
hicle more often in areas with high levels
of atmospheric pollution or salted roads.
To correctly wash the vehicle, follow these
in
structions:
If high pressure jets or cleaners are used
to wash the vehicle, keep a distance of at
least 1.3
ft (40 cm) from the bodywork to
av
oid damage or alteration. Build up of
water could cause damage to the vehicle
in the long term.
Wash the vehicle using a low pressure jet
of water if possible.
Wipe a sponge with a slightly soapy solu-
tion over the bodywork, frequently rinsing
th
e sponge.
Rinse well with water and dry with a jet of
air or a chamois leather.
Loading ...
Loading ...
Loading ...