Loading ...
Loading ...
Loading ...
IN CASE OF EMERGENCY
220
Mounting The Tire
Proceed as follows:
1. Remove dirt and grime from the
m
ounting surfaces of the wheel and hub,
including the hub bolts, with a cloth.
Clean Mounting Surface
2. Mount the tire and install the lug nuts
w
ith the beveled edge inward, then
tighten them by hand.
3. Turn the lug wrench counterclockwise
a
nd lower the vehicle. Use the lug
wrench to tighten the nuts in the order
shown.
Lug Nut Tightening Order
4. After tightening the lug nuts, have them
c
hecked with a torque wrench by an
authorized dealer or service station to
verify correct tightness.
5. Remove the tire blocks and store the
t
ools and jack.
6. Check the inflation pressure. Refer to
“
Recommended Tire Inflation Pressure”
in Technical Specifications” for more
information.
With TPMS
Do not push the tire pressure monitoring
s
y
stem set switch after installing the spare
tire. The switch is only to be pushed after
installing the repaired flat tire or installing a
replacement tire.
NOTE:
To prevent the jack and tool from rattling,
s
t
ore them properly.
CAUTION!
Be sure to mount the spare tire with the
valve stem facing outward. The vehicle
could be damaged if the spare tire is
mounted incorrectly.
WARNING!
To avoid the risk of forcing the vehicle off
the jack, do not tighten the wheel nuts
fully until the vehicle has been lowered.
Failure to follow this warning may result in
serious injury.
WARNING!
A loose tire or jack thrown forward in a
collision or hard stop could endanger the
occupants of the vehicle. Always stow the
jack parts and the spare tire in the places
provided. Have the deflated (flat) tire
repaired or replaced immediately.
Loading ...
Loading ...
Loading ...