Loading ...
Loading ...
Loading ...
269
(Continued)
NOTE:
If you intend parking or storing your vehicle
fo
r an extended period after cleaning the
wheels with wheel cleaner, drive your vehicle
and apply the brakes to remove the water
droplets from the brake components. This
activity will remove the red rust on the brake
rotors and prevent vehicle vibration when
braking.
Dark Vapor Chrome, Black Satin Chrome, or
Lo
w Gloss Clear Coat Wheels
Snow Chains
The use of snow chains should be in compli-
ance with local regulations of each country.
In
certain countries, tires marked with code
M+S (Mud and Snow) are considered as
winter equipment; therefore their use is
equivalent to that of the snow chains.
The snow chains may be applied only to the
fr
ont wheel tires. Check the tension of the
snow chains after the first few feet have been
driven.
CAUTION!
Do not use scouring pads, steel wool, a
bristle brush, metal polishes or oven
cleaner. These products may damage the
wheel's protective finish. Such damage is
not covered by the New Vehicle Limited
Warranty. Only car wash soap, Mopar
Wheel Cleaner or equivalent is
recommended.
CAUTION!
If your vehicle is equipped with these
specialty wheels, DO NOT USE wheel
cleaners, abrasives, or polishing
compounds. They will permanently
damage this finish and such damage is not
covered by the New Vehicle Limited
Warranty. HAND WASH ONLY USING
MILD SOAP AND WATER WITH A SOFT
CLOTH. Used on a regular basis; this is all
that is required to maintain this finish.
WARNING!
Using tires of different size and type
(M+S, Snow) between front and rear axles
can cause unpredictable handling. You
could lose control and have a collision.
CAUTION!
To avoid damage to your vehicle or tires,
observe the following precautions:
Because of restricted traction device
clearance between tires and other
suspension components, it is important
that only traction devices in good condi
-
tion are used. Broken devices can cause
se
rious damage. Stop the vehicle imme-
diately if noise occurs that could indi-
cate device breakage. Remove the
d
a
maged parts of the device before
further use.
Install device as tightly as possible and
then retighten after driving about ½ mile
(0.8
km).
Do not exceed 30 mph (48 km/h).
Drive cautiously and avoid severe turns
and large bumps, especially with a
loaded vehicle.
Loading ...
Loading ...
Loading ...