Loading ...
Loading ...
Loading ...
20
©
2019 DJI All Rights Reserved.
ROBOMASTER S1
User Manual
DO NOT aim the blaster at people or animals when launching the gel beads.
DO NOT point the launch trajectory light at the eyes of people or animals.
Preparing the Gel Beads
The S1 Blaster can launch gel beads. The gel beads must be soaked in water in advance. Follow
the steps below to soak the gel beads.
1. Use the gel bead bottle cap to measure the number of gel beads. One gel bead bottle cap holds
approximately 500 rounds.
2. It is recommended to soak the gel beads in 1000 ml of purified water for four hours at room
temperature before use. The soaked gel beads have a diameter of 5.9-6.8 mm and a mass of
0.12-0.17 g.
The size of soaked gel beads may vary if water of different quality is used. Soak according
to the specications to avoid blocking the Blaster.
Loading the Gel Beads
Follow the steps below to load the gel beads. The loading capacity of the gel bead container is
approximately 430 rounds. Load the required number of gel beads according to the usage.
3
5
2
1
4
After each use, make sure to clear the gel beads in the gel bead container to prevent
accidental injury.
DO NOT swallow the gel beads.
Make sure to keep the gel beads out of reach of children and animals.
Do not freeze gel beads that have been soaked during use. Otherwise, the gel beads will
harden and block the blaster or may cause injury.
Loading ...
Loading ...
Loading ...