Loading ...
Loading ...
Loading ...
600 | Chapter 8. Maintenance
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
To configure the Traceroute settings and send probe packets to discover the route to a host
on the network:
1. Use IP Address/Hostname to enter the IP address or Hostname of the station you want
the switch to discover path. The initial value is blank. The IP Address or Hostname you
enter is not retained across a power cycle.
2. Optionally, configure the following settings:
• Probes Per Hop - Enter the number of probes per hop. The initial value is default. The
Probes per Hop you enter is not retained across a power cycle.
• MaxTTL - Enter the maximum TTL for the destination. The initial value is default
value. The MaxTTL you enter is not retained across a power cycle.
• InitTTL - Enter the initial TTL to be used. The initial value is default value. The InitTTL
you enter is not retained across a power cycle.
• MaxFail - Enter the maximum Failures allowed in the session. The initial value is
default value. The MaxFail you enter is not retained across a power cycle.
• Interval(secs) - Enter the Time between probes in seconds. The initial value is default
value. The Interval you enter is not retained across a power cycle.
• Port - Enter the UDP Dest port in probe packets. The initial value is default value. The
port you enter is not retained across a power cycle.
• Size - Enter the Size of probe packets. The initial value is default value. The Size you
enter is not retained across a power cycle.
3. Click Cancel to cancel the operation on the screen and reset the data on the screen to the
latest value of the switch.
4. Click Apply to initiate the traceroute. The results display in the TraceRoute area.
Loading ...
Loading ...
Loading ...